Brother MFC-9100C manual Remote Commands, Off

Remote Commands

Follow the commands below to access features remotely. When you call the MFC and enter your Remote Retrieval Access Code (1 5 9 ), the system will signal you with two short beeps to enter a remote command.

Remote Commands			Operation Details
95	Changing Fax Forwarding/
	Paging setting
	1	OFF	If you hear one long beep, the change is
			accepted. If you hear three short beeps, you
	2	Fax Forwarding
			cannot change it because the conditions have
	3	Paging	not been met. (Example: registering paging
			number.) You can register your fax
	4	FAX FWD No.
			forwarding number by using 4. FAX FWD
			NO. (See page 8-6.) Once you have
			registered the number, your MFC will change
			automatically to FAX FWD:ON mode. Then
			retrieve a Memory Status List by entering
			961 (see page 8-5) to make sure that the Fax
			Forwarding number you registered is correct
			in the List.
	6	Fax Storage ON	You can turn FAX STORAGE to ON or OFF.
	7	Fax Storage OFF
96	Retrieve a fax
	1	Memory Status List	Enter the number of a remote fax machine to
			receive the Memory Status List or stored fax
	2	Retrieve all faxes
			message(s). (See page 8-5.)
	3	Erase fax from the	If you hear one long beep, you can erase fax
		memory	message(s) from the memory.
97 Check the Receiving Status
	1	Fax	You can check whether your MFC has
			received any fax message(s). If yes, you will
			hear one long beep. If no, you will hear three
			short beeps.
98	Change Answer Mode		If you hear one long beep, you can change the
	1	EXT. TEL/TAD
			Answer Mode. If you hear three short beeps,
	2	FAX	you cannot change it.
90	Exit		After a long beep, you can exit remote control.

8 - 4 R E M O T E F A X O P T I O N S