Casio ISA550WBUN3K9 manual Viewing Status of Physical Interfaces

Networking	4
Managing Ports

•Configuring Port Mirroring, page 119

•Configuring Port-Based (802.1x) Access Control, page 120

Viewing Status of Physical Interfaces

Use the Networking > Ports > Physical Interface page to view information about all physical ports on the security appliance.

For all models, the following information appears:

•Name: The name of the physical port.

•Enable: Shows if the physical port is enabled or disabled.

•Port Type: The type of the physical port, such as WAN, LAN, or DMZ.

•Mode: The access mode of the physical port. A WAN or DMZ port is always set to the Access mode. A LAN port can be set to the Access or Trunk mode.

•VLAN: The VLANs to which the physical port is mapped.

•PVID: The Port VLAN ID (PVID) is used to forward or filter the untagged packets coming into port. The PVID of a trunk port is fixed to the DEFAULT VLAN (1).

•Speed/Duplex: The duplex mode (speed and duplex setting) of the physical port.

•Link Status: Shows if the physical port is connected or disconnected.

For the ISA550W and the ISA570W, the Wireless Interfaces area displays the following information for all SSIDs:

•SSID Name: The name of the SSID.

•VLAN: The VLAN to which the SSID is mapped.

•Client Associated: The number of client stations that are connected to the SSID.

NOTE: To configure your wireless network, go to the Wireless pages. See Wireless (for ISA550W and ISA570W only), page 206.

Cisco ISA500 Series Integrated Security Appliances Administration Guide 117