Casio ISA550WBUN3K9 manual Configuring DMZ

Configuration Wizards	2
Using the Setup Wizard for the Initial Configuration

-DHCP Server: Allows the security appliance to act as a DHCP server and assigns IP addresses to all devices that are connected to the LAN. Any new DHCP client joining the LAN is assigned an IP address of the DHCP pool.

-DHCP Relay: Allows the security appliance to use a DHCP Relay. If you choose DHCP Relay, enter the IP address of the remote DHCP server in the Relay IP field.

STEP 27 If you choose DHCP Server as the DHCP mode, enter the following information:

•Start IP: Enter the starting IP address of the DHCP pool.

•End IP: Enter the ending IP address of the DHCP pool.

NOTE: The Start IP address and End IP address should be in the same subnet as the LAN IP address.

•Lease Time: Enter the maximum connection time that a dynamic IP address is “leased” to a network user. When the time elapses, the user is automatically renewed the dynamic IP address.

•DNS1: Enter the IP address of the primary DNS server.

•DNS2: Optionally, enter the IP address of the secondary DNS server.

•WINS1: Optionally, enter the IP address of the primary WINS server.

•WINS2: Optionally, enter the IP address of the secondary WINS server.

•Domain Name: Optionally, enter the domain name for the default LAN.

•Default Gateway: Enter the IP address of default gateway.

STEP 28 After you are finished, click Next.

Configuring DMZ

STEP 29 If you have not configured a DMZ port, proceed to Configuring Wireless Radio Settings, page 47. If you configured a DMZ port, use the DMZ Configuration page to configure a DMZ network.

•IP Address: Enter the subnet IP address for the DMZ.

•Netmask: Enter the subnet mask for the DMZ.

Cisco ISA500 Series Integrated Security Appliances Administration Guide 44