Casio ISA550WBUN3K9 manual Configuring DMZ Network

Configuration Wizards	2
Using the DMZ Wizard to Configure DMZ Settings

STEP 5 Enter the following information:

•Service: Choose either DynDNS or No-IP service.

NOTE: You must sign up for an account with either one of these providers before you can use this service.

•Active On Startup: Click On to activate the DDNS setting when the security appliance starts up.

•WAN Interface: Choose the WAN port for the DDNS service. Traffic for DDNS services will pass through the specified WAN port.

NOTE: If the WAN redundancy is set as the Failover mode, this option is grayed out. When WAN failover occurs, DDNS will switch traffic to the active WAN port.

•User Name: Enter the username of the account that you registered in the DDNS provider.

•Password: Enter the password of the account that you registered in the DDNS provider.

•Host and Domain Name: Specify the complete host name and domain name for the DDNS service.

•Use wildcards: Check this box to allow all sub-domains of your DDNS host name to share the same public IP address as the host name.

•Update every week: Check this box to update the host information every week.

STEP 6 Click OK to save your settings.

STEP 7 After you are finished, click Next.

Configuring DMZ Network

STEP 8 Use the DMZ Configuration page to configure the DMZ networks.

NOTE: Up to 4 DMZ networks can be configured on the security appliance. You must configure at least one DMZ network to finish the DMZ wizard.

STEP 9 Click Add to create a DMZ network.

Other options: To edit an entry, click the Edit (pencil) icon. To delete an entry, click the Delete (x) icon.

Cisco ISA500 Series Integrated Security Appliances Administration Guide 72