Casio ISA550WBUN3K9 manual Logging in to the Configuration Utility

Getting Started	1
Getting Started with the Configuration Utility

Logging in to the Configuration Utility

STEP 1 Connect your computer to an available LAN port on the back panel.

Your PC will become a DHCP client of the security appliance and will receive an IP address in the 192.168.75.x range.

STEP 2 Start a web browser. In the address bar, enter the default IP address of the security appliance: 192.168.75.1.

NOTE: The above address is the factory default LAN address. If you change this setting, enter the new IP address to connect to the Configuration Utility.

STEP 3 When the login page opens, enter the username and password.

The default username is cisco. The default password is cisco. Usernames and passwords are case sensitive.

STEP 4 Click Login.

STEP 5 For security purposes, you must change the default password of the default administrator account. Set a new administrator password and click OK.

STEP 6 If you can access the Internet and a newer firmware is detected, the Firmware Upgrade window opens. Follow the on-screen prompts to download and install the firmware. See Upgrading your Firmware After your First Login, page 33.

STEP 7 If you cannot access the Internet or you are using the latest firmware, the Setup Wizard will now launch. Follow the on-screen prompts to complete the initial configuration. See Using the Setup Wizard for the Initial Configuration, page 36.

Cisco ISA500 Series Integrated Security Appliances Administration Guide 26