Casio ISA550WBUN3K9 manual Configuring Local and Remote Networks, Viewing Configuration Summary

Configuration Wizards	2
Using the Site-to-Site VPN Wizard to Configure Site-to-Site VPN

STEP 13 Click OK to save your settings.

STEP 14 After you are finished, click Next.

Configuring Local and Remote Networks

STEP 15 Use the Local and Remote VPN Networks page to configure the local and remote networks.

•Local Subnet: Choose the IP address for your local network. Choose Any if you want to enable the zone access control settings so that you can control incoming traffic from remote VPN network to the zones over the VPN tunnels.

•Remote Subnet: Choose the IP address for the remote network. You must know the IP address of the remote network before connecting the VPN tunnel.

If the IP address object that you want is not in the list, choose Create a new address to add a new address object or choose Create a new address group to add a new address group object. To maintain the address and address group objects, go to the Networking > Address Management page. See Address Management, page175.

NOTE: The security appliance can support multiple subnets for establishing the VPN tunnels. You should select an address group object including multiple subnets for local and remote networks.

STEP 16 After you are finished, click Next.

Viewing Configuration Summary

STEP 17 Use the Summary page to view information for the IPsec VPN policy.

STEP 18 To modify any settings, click Back. If the configuration is correct, click Finish to apply your settings.

STEP 19 After you click Finish, a warning message appears saying “Do you want to make this connection active when the settings are saved? (Only one connection can be active at a time.)”

•If you want to immediately activate the connection after the settings are saved, click Activate Connection. After you save your settings, the security appliance will immediately try to initiate the VPN connection.

Cisco ISA500 Series Integrated Security Appliances Administration Guide 70