VPN

8

 

Configuring a Site-to-Site VPN

 

 

 

 

 

WAN Interface: The WAN port that traffic passes through over the IPsec VPN tunnel.

Peers: The IP address of the remote peer.

Local: The local network of the local peer.

Remote: The remote network of the remote peer.

IKE: The IKE policy used for the IPsec VPN policy.

Transform: The transform set used for the IPsec VPN policy.

STEP 2 Click On to enable site-to-site VPN, or click Off to disable it.

NOTE: Enabling the Site-to-Site VPN feature will disable the Teleworker VPN

Client feature.

STEP 3 If you enable site-to-site VPN, perform the following actions:

To add a new IPsec VPN policy, click Add. See Configuring IPsec VPN Policies, page 343.

To edit an existing IPsec VPN policy, click the Edit (x) icon.

To delete an IPsec VPN policy, click the Delete (x) icon.

To delete multiple IPsec VPN policies, check them and click Delete.

To enable an IPsec VPN policy, check the box in the Enable column.

To manually establish a VPN tunnel, click the Connect icon for an enabled IPsec VPN policy.

To manually terminate a VPN connection, click the Disconnect icon.

To refresh the data for site-to-site VPN, click Refresh.

STEP 4 Click Save to apply your settings.

Cisco ISA500 Series Integrated Security Appliances Administration Guide

342

Page 342
Image 342
Casio ISA550WBUN3K9 manual Vpn