Note This command works only on platforms supporting 12X link aggregation.

The option portName is case sensitive. If it contains spaces, it must be bounded by quotes (e.g., ismPortSet12x "Cable 1", 1). Using this command without the option enable12xBit displays the current values of the port.

Devices with affected ports MUST BE REBOOTED to activate changes made with ismPortSet12x.This reboot will be disruptive and will cause the affected switch chips to be reset and have a part of their EEPROM to be reloaded.

ismChassisSet12x

Note This command is not currently supported.

Allows the user to view, set and unset the chassis link width to 12X (including external ports).

Syntax:

ismChassisSet12x [enable12xBit]

Options:

-enable12xBit

1=enable, 0=disable.

Sample Output:

-> ismChassisSet12x

L01P01

12x

mode is DISABLED

L01P02

12x

mode is DISABLED

L01P03

12x

mode is DISABLED

L01P04

12x

mode is DISABLED

L01P05

12x

mode is DISABLED

L01P06

12x

mode is DISABLED

L01P07

12x

mode is DISABLED

L01P08

12x

mode is DISABLED

L01P09

12x

mode is DISABLED

L01P10

12x

mode is DISABLED

L01P11

12x

mode is DISABLED

Note This command works only on platforms supporting 12X link aggregation.

This command will enable 12X link aggregation so that internal and external switching will be 12x. Each 12X port is 3 aggregated 4x ports (i.e., a TRIO), where one will be reported as a 12x port, and the other two ports are reported as disabled. Each of the three aggregated 4x ports must be connected to another enabled 12X TRIO to establish a 12X link. Using this command without the option enable12xBit displays the ports current values. The device must be rebooted to activate changes made with this command.

Calling this command without the enable12xBit will display the current values of the port(s).

Cisco SFS 7012 InfiniBand Server Switch Hardware Users Guide

 

OL-8787-05

B-61

 

Page 153
Image 153
Cisco Systems SFS 7012 manual IsmChassisSet12x enable12xBit