Emerson Process Management 8732 manual Resource Block Errors, Modes

Reference Manual

00809-0100-4663, Rev BA January 2010

Rosemount 8732

RESOURCE BLOCK ERRORS

Table F-2. Resource BLOCK_ERR Conditions

Table F-2lists conditions reported in the BLOCK_ERR parameter. Conditions in italics are inactive for the resource block and are given here only for your reference.

Condition
Number	Condition Name and Description
1	Block Configuration Error: A feature in FEATURES_SEL is set that is
	not supported by FEATURES or an execution cycle in CYCLE_SEL is
	set that is not supported by CYCLE_TYPE.
2	Link Configuration Error: A link used in one of the function blocks is
	improperly configured.
3	Simulate Active: The simulation jumper is in place. Simulate active is
	not an indication that the I/O blocks are using simulated data.
4	Local Override
5	Device Fault State Set
6	Device Needs Maintenance Soon
7	Input failure/process variable has bad status
8	Output Failure: The output is bad based primarily upon a bad input.
9	Memory Failure: A memory failure has occurred in FLASH, RAM, or
	EEPROM memory.
10	Lost Static Data: Static data that are stored in nonvolatile memory have
	been lost.
11	Lost NV Data: Nonvolatile data that are stored in nonvolatile memory
	have been lost.
12	Readback Check Failed
13	Device Needs Maintenance Now
14	Power Up: The device was just powered-up.
15	Out of Service: The actual mode is out of service.

MODES	The resource block supports two modes of operation as defined by the
	MODE_BLK parameter:
	• Automatic (Auto)—The block is processing its normal background
	memory checks.
	• Out of Service (O/S)—The block is not processing its tasks. When the
	resource block is in O/S, all blocks within the resource (device) are
	forced into O/S. The BLOCK_ERR parameter shows OUT OF
	SERVICE. In this mode, you can make changes to all configurable
	parameters. The target mode of a block may be restricted to one or
	more of the supported modes.

F-5