Emerson Process Management 8732 manual Transducer Block Errors, Condition Name and Description

Rosemount 8732

Reference Manual

00809-0100-4663, Rev BA January 2010

TRANSDUCER BLOCK ERRORS

Table G-4. Transducer

BLOCK_ERR and XD_ERR

Conditions

The following conditions are reported in the BLOCK_ERR and XD_ERROR parameters. Conditions in italics are inactive for the transducer block and are given here only for your reference.

Condition
Number	Condition Name and Description
1	Block Configuration Error
2	Link Configuration Error
3	Simulate Active
4	Local Override
5	Device Fault State Set
6	Device Needs Maintenance Soon
7	Input Failure/Process Variable Has Bad Status
8	Output Failure
9	Memory Failure
10	Lost Static Data
11	Lost NV Data
12	Readback Check Failed
13	Device Needs Maintenance Now
14	Power Up: The device was just powered-up.
15	Out of Service: The actual mode is out of service.
16	Unspecified Error: An unidentified error occurred.
17	General Error: A general error that cannot be specified below occurred.
18	Calibration Error: An error occurred during calibration of the device, or
	a calibration error was detected during normal operations.
19	Configuration Error: An error occurred during configuration of the
	device, or a configuration error was detected during normal operations.
20	Electronics Failure: An electrical component failed.
21	Mechanical Failure: A mechanical component failed.
22	I/O Failure: An input/output (I/O) failure occurred.
23	Data Integrity Error: Data stored in the device are no longer valid due
	to a nonvolatile memory checksum failure, a data verify after write
	failure, etc.
24	Software Error: The software has detected an error due to an improper
	interrupt service routine, an arithmetic overflow, a watchdog time-out,
	etc.
25	Algorithm Error: The algorithm used in the transducer block produced
	an error due to overflow, data reasonableness failure, etc.

G-4