Emerson Process Management 8732 manual OFF KEY Disabled

Reference Manual

00809-0100-4663, Rev BA January 2010

Rosemount 8732

Table H-1. Handheld Communicator Diagnostic Messages

Message	Description
OFF KEY DISABLED	Appears when the user attempts to turn the HC off before sending
	modified data or before completing a method
On-line device disconnected with unsent data – RETRY or OK to	There is unsent data for a previously connected device. Press RETRY
lose data	to send data, or press OK to disconnect and lose unsent data.
Out of memory for hot key configuration – delete unnecessary	There is no more memory available to store additional hot key items.
items	Unnecessary items should be deleted to make space available.
Overwrite existing configuration memory	Requests permission to overwrite existing configuration either by a
	device-to-memory transfer or by an off-line configuration; user answers
	using the softkeys
Press OK...	Press the OK softkey – this message usually appears after an error
	message from the application or as a result of hart communications.
Restore device value?	The edited value that was sent to a device was not properly
	implemented. Restoring the device value returns the variable to its
	original value.
Save data from device to configuration memory	Prompts user to press SAVE softkey to initiate a device-to-memory
	transfer
Saving data to configuration memory	Data is being transferred from a device to configuration memory.
Sending data to device	Data is being transferred from configuration memory to a device.
There are write only variables which have not been edited.	There are write-only variables which have not been set by the user.
Please edit them.	These variables should be set or invalid values may be sent to the
	device.
There is unsent data. Send it before shutting off?	Press YES to send unsent data and turn the HC off. Press NO to turn
	the HC off and lose the unsent data.
Too few data bytes received	Command returns fewer data bytes than expected as determined by the
	device description
Transmitter Fault	Device returns a command response indicating a fault with the
	connected device
Units for <variable label> has changed – unit must be sent before	The engineering units for this variable have been edited. Send
editing, or invalid data will be sent	engineering units to the device before editing this variable.
Unsent data to on-line device – SEND or LOSE data	There is unsent data for a previously connected device which must be
	sent or thrown away before connecting to another device.
Use up/down arrows to change contrast. Press DONE when done.	Gives direction to change the contrast of the HC display
Value out of range	The user-entered value is either not within the range for the given type
	and size of variable or not within the min/max specified by the device.
<message> occurred reading/writing <variable label>	Either a read/write command indicates too few data bytes received,
	transmitter fault, invalid response code, invalid response command,
	invalid reply data field, or failed pre- or post-read method; or a response
	code of any class other than SUCCESS is returned reading a particular
	variable.
<variable label> has an unknown value – unit must be sent before	A variable related to this variable has been edited. Send related variable
editing, or invalid data will be sent	to the device before editing this variable.

H-7