Emerson Process Management 8732 manual Parameter Index Number Definition, Densityvalue

Rosemount 8732

Reference Manual

00809-0100-4663, Rev BA January 2010

PARAMETERS AND DESCRIPTIONS

Table G-1. Transducer Block Parameters

Table G-1lists all of the configurable parameters of the transducer block, indicating the descriptions and index numbers for each parameters.

Parameter	Index Number	Definition
ALERT_KEY	4	ID number of the transmitter–may be used on the host for sorting alarms
BLOCK_ALM	8	Block alarm
COIL_DRIVE_FREQ	35	Frequency at which the coils are being driven (5 or 37.5 Hz)
DAMPING	30	Damping filter value (in seconds)
DENSITY_UNIT	31	Unit code associated with DENSITY_VALUE. Valid values are lb/cubic feet, or
		kg/cubic meter
DENSITY_VALUE	75	User entered density value to be used by the transducer block when calculating flow
		rate in mass flow units
DIAGNOSTIC_HANDLING	60	On/Off handling for diagnostics
ELECTRODE_MATERIAL	51	Enumerated string indicating flange material of installed flowtube
ELECTRODE_TYPE	52	Enumerated string indicating electrode type of installed flowtube
EP_TRIG_COUNTS	40	Number of EP measurements that must be above the trigger level to set empty pipe
EP_TRIG_LEVELS	41	Empty Pipe Trigger Levels
FLANGE_MATERIAL	54	Enumerated string indicating liner material of installed flowtube
FLANGE_TYPE	53	Enumerated string indicating liner material of installed flowtube
FLOW_TUBE_SERIAL_NUMBER	49	Flow tube serial number from physical tag on flowtube
FLOW_TUBE_TAG	48	Text String Identifier of flowtube
LICENSE_KEY	78	Key/password to enable diagnostic features. Any changes to the licensing will be
		shown in the LICENSE_STATUS parameter
LINER_MATERIAL	50	Enumerated string indicating liner material of installed flowtube
LOI_LANG	39	Selects the language to be used in the local display for status and diagnostics
		messages
LOW_FLOW_CUTOFF	37	When flow rate is less than this entered value, flow rate output will be set to 0 ft/s
MODE_BLK	5	Mode of the record of the block–contains the actual, target, permitted,
		and normal modes
SENSOR_CAL_DATE	25	Date of the last sensor calibration–intended to reflect the calibration of the sensor
SENSOR_CAL_LOC	24	Location of the last sensor calibration–describes the physical location at which the
		calibration was performed
SENSOR_CAL_METHOD	23	Method of the last sensor calibration–ISO defines several standard methods of
		calibration (This parameter is intended to record that method or if some other method
		was used.)
SENSOR_CAL_WHO	26	Name of the person responsible for the last sensor calibration
STATUS_MESSAGE_MFG	61	Used by manufacturing to test groups to simulate status codes
STRATEGY	3	Can be used to help group the blocks (Not checked or processed by the block)
TAG_DESC	2	Static tag–ASCII character string
TUBE_CAL_NO	33	Sensor gain and zero offset number used in flow calculation
		(Number entered is locate on physical tag of the sensor.)
TUBE_SIZE	34	Tube Size. See Tube Size for actual line sizes
UPDATE_EVT	7	Update event

G-2