Emerson Process Management 8732 manual FLOW-SPECIFIC Block Configuration Values

Reference Manual

00809-0100-4663, Rev BA January 2010

Rosemount 8732

FLOW-SPECIFIC BLOCK CONFIGURATION VALUES

Once the transmitter is installed and communication is established, configuration must be completed. Three parameters must be entered for proper configuration:

•Sensor calibration number

•Engineering units (configured via AI block)

•Sensor size

The sensor calibration number can be found on the sensor nameplate. A list of all possible sensor sizes and engineering units are listed in Table G-2and Table G-3. Mass units (lb, kg, ton, and ston) require configuration of the

DENSITY_VALUE.

Table G-2. Supported Line Sizes

	User-Defined Sensor Line Size
0.1 in. (3 mm)		16 in. (400 mm)
0.15 in. (4 mm)		18 in. (450 mm)
0.25 in. (6 mm)		20 in. (500 mm)
0.3 in (8 mm)		24 in. (600 mm)
0.5 in. (15 mm)		28 in. (700 mm)
0.75 in. (20 mm)		30 in. (750 mm)
1 in. (25 mm)		32 in (800 mm)
1.5 in. (40 mm)		36 in. (900 mm)
2 in. (50 mm)		40 in. (1000 mm)
2.5 in. (65 mm)		42 in. (1050 mm)
3 in. (80 mm)(1)		48 in. (1200 mm)
4 in. (100 mm)		54 in. (1350 mm)
6 in. (150 mm)		56 in. (1400 mm)
8 in. (200 mm)		60 in. (1500 mm)
10 in. (250 mm)		64 in. (1600 mm)
12 in. (300 mm)		72 in. (1800 mm)
14 in. (350 mm)		80 in. (2000 mm)
(1) Default Factory Configuration

Table G-3. Supported

Engineering Units				User Defined Engineering Units
	•	ft/s(1)	•	CFS	•	bbl/s	•	kg/s
	•	ft/m	•	CFM	•	bbl/min	•	kg/min
	•	ft/h	•	CFH	•	bbl/h	•	kg/h
	•	m/s	•	ft3/d	•	bbl/d	•	kg/d
	•	m/h	•	m3/s	•	cm3/s	•	STon/s
	•	gal/s	•	m3/min	•	cm3/min	•	STon/min
	• GPM		• m3/h		• cm3/h		• STon/h
	•	gal/h	•	m3/d	•	cm3/d	•	STon/d
	•	gal/d	•	IGAL/s	•	lb/s	•	t/s
	•	L/s	•	IGAL/min	•	lb/min	•	t/min
	•	L/min	•	IGAL/h	•	lb/h	•	t/h
	•	L/h	•	IGAL/d	•	lb/d	•	t/d
	•	L/d
	(1) Default factory configuration

G-3