EPSON AcuLaser C1100 Revision B
DISASSEMBLY AND ASSEMBLY MSI 304
4.3 MSI

4.3.1 MSI ASSY

REMOVAL
1. Remove COVER ASSY RH. (p.301)
2. Remove COVER ASSY LH. (p.295)
3. Remove COVER MSI. (p.291)
4. Remove COVER FRONT L and COVER FRONT ASSY U. (p.292)
5. Remove FRAME ASSY-PH. (p.327)
6. Disconnect connector (P/J408) and connector (P/J409) from PWBA MCU.
7. Unclamp the two clamps on CHASSIS ESS, and disconnect the harness from
HARNESS-ASSY P/H 1.
8. Remove the 6 screws (silver, with fl ange, tapping, 8 mm) fastening MSI AS SY to
the main unit.
9. Draw out MSI ASSY slightly toward you, lift up MSI ASSY slightly to avoid TIE
PLATE under the main unit, gently draw out MSI ASSY forward again and draw
out HARNESS-ASSY P/H 1 from the hole on the main unit to remove MSI ASSY.
Figure 4-23. Removal of MSI ASSY
C A U T IO N Step numbers with [ ] in the figure indicate the step of
reinstallation.
C A U T IO N When performing the following work, take care to prevent the
cable tie that bundles the harness of HARNESS-ASSY P/H 1
from being caught on the holes, etc. on the main unit.
When performing the following work, take care to prevent the
HARNESS-ASSY P/H 1 from being sandwiched between the
main unit and MSI ASSY.
Leg_Sec03_042EB
CAUTION
6)
7)
9)-2
8)
8)
8)
8)
8)
8)
7)
6)
9)-1