Epson SEPG04002 - page 441

EPSON AcuLaser C1100 Revision B
DISASSEMBLY AND ASSEMBLY DUPLEX 441
REINSTALLATION
1. Insert the shaft left side on ROLLER ASSY DUP into the left-side bearing on
DUPLEX ASSY, and slide ROLLER ASSY DUP to the right to attach.
2. Match the double D cut surface of BEARING DUP with the left and right bearings
of DUPLEX ASSY, attach BEARING DUP, and fasten ROLLER ASSY DUP.
3. Fasten the right side of ROLLER ASSY DUP to DUPLEX ASSY with the E-ring.
4. Match the hole on GEAR 30 with the D cut surface on ROLLER ASSY DUP,
fasten the hook on GEAR 30 to the groove on ROLLER ASSY DUP, and attach.
5. Match the hole on BKT MOTOR DUP TRANS with the shaft on DUPLEX
ASSY, and attach together with PWBA DUP-L and MOTOR ASSY DUP.
6. Fasten BKT MOTOR DUP TRANS to DUPLEX ASSY with the 4 screws (silver,
with flange, tapping, 10mm).
7. Connect connector (P/J444) to PWBA DUP-L.
8. Route the harness, and fasten the harness by the clamp on BKT MOTOR DUP
TRANS.
9. Attach COVER UP-DUP TRANS. (p.437)
10. Attach COVER LOW-DUP TRANS. (p.436)
11. Attach COVER-L DUP. (p.414)
12. Attach COVER-R DUP. (p.413)
13. Attach DUPLEX ASSY. (p.412)
Figure 4-141. Removal of ROLLER ASSY DUP (2)
Leg_Sec03_138FA
13)
11) 12)
12)
10)-1
10)-2