EPSON AcuLaser C1100 Revision B
PRODUCT DESCRIPTION Controller Specifications 46
1.14 Controller Specifications

1.14.1 Controller Basic Specifications

CPU : VR4305 (66.7 MHz)
Enhanced technology : CPGI, CRIT, RITech (the ASIC uses HTC)
RAM : SDRAM
Standard : 32 MB (mounted on the code ROM DIMM side)
Expansion : 16 MB, 32 MB, 64 MB, 128 MB, 256 MB
(90pin DIMM)
1 slot, maximum 256 MB
Program ROM : 4 MB Flash (DIMM)
Panel : LCD 20 digits, 1 line; 3 LEDs; 6 switches
Interface
Standard
•Parallel : 1 ch (IEEE1284 compliant bi-directional B-type
connector, Compatibility, Nibble, ECP)
•USB : 1 ch (Rev.2.0 HS) (D4 Level 3 supported)
•Network interface board: 1 slot
Printer mode
Standard : ESC/PageS Printing System (ESC/PageS03)
Other : EJL mode
RCC mode
DCC mode
EpsonNet Config (Web)
Auxiliary software : Status sheet
Maintenance mode (engine status sheet)
Update function for mechanical controller firmware
(EFU)
Installation method : Fixed to the main body

1.14.2 Controller Configuration

The printer can be set with the following configurations according to destination.
C A U T IO N Even if 256 MB memory is installed, available size is not become
288 MB because of restriction of ASIC.
CHECK
P O IN T
There are 2 models, either Network interface board is installed or
not installed.
However, attaching the board to the “not installed model” is
possible.
Table 1-35. Pattern jumper (INPT0)
R190
Open 1Default for tray paper size: A4
Short 0Default for tray paper size: LT