EPSON AcuLaser C1100 Revision B
DISASSEMBLY AND ASSEMBLY DUPLEX 440
4.12.24 ROLLER ASSY DUP
REMOVAL
1. Remove DUPLEX ASSY. (p.412)
2. Remove COVER-R DUP. (p.413)
3. Remove COVER-L DUP. (p.414)
4. Remove COVER LOW-DUP TRANS. (p.436)
5. Remove COVER UP-DUP TRANS. (p.437)
6. Unclamp the clamp on BKT MOTOR DUP TRANS, and remove the harness.
7. Disconnect connector (P/J444) from PWBA DUP-L.
8. Remove the 4 screws (silver, with flange, tapping, 10mm) fastening BKT
MOTOR DUP TRANS to DUPLEX ASSY.
9. Remove BKT MOTOR DUP TRANS from DUPLEX ASSY together with PWBA
DUP-L and MOTOR ASSY DUP.
10. Unhook the hook on GEAR 30 fastened to ROLLER ASSY DUP, and remove
GEAR 30 from DUPLEX ASSY.
11. Remove the E-ring fastening the right side of ROLLER ASSY DUP from
DUPLEX ASSY.
12. Remove the left and right BEARING DUP fastening ROLLER ASSY DUP from
DUPLEX ASSY.
13. Temporarily slide ROLLER ASSY DUP to the left, and draw out the shaft of
ROLLER ASSY DUP from the right-side bearing of DUPLEX ASSY to remove
ROLLER ASSY DUP.
Figure 4-140. Removal of ROLLER ASSY DUP (1)
C A U T IO N When performing the following work, take care not to remove
DUPLEX ASSY and BKT MOTOR DUP TRANS too far as
they are connected by a harness.
When performing the following work, take care not to drop or
lose gears, and other parts. Leg_Sec03_128FB
6)
7)
8)

8) 8)

8) 9)