EPSON AcuLaser C1100 Revision B
PRODUCT DESCRIPTION Printer Status 61
Invalid N/W Module
Explanation
The network program does not exist, or a network program that is not for this
printer is written.
The interfaces maintain the status before the error.
Replace Photocondctr
Explanation
Photoconductor Unit has reached the end of its service life
Remedy
Same message is displayed, but error LED flash 2 different ways either on or
flashes.
1. When error LED is on
• Replace the Photoconductor Unit with a new one. The printer recovers from the
error when the cover B is closed.
2. When error LED flashes
• Replace the Photoconductor Unit with a new one. The printer recovers from the
error when the cover B is closed.
• Although the printer recovers from the error by pressing the Start/Stop button, the
print quality is not guaranteed from then.
NOTE: Error removing spec is as below.
•
When Start/Stop button is pressed, the message changes to “Worn
Photoconductor”. Printing is possible until the error LED is on indicating
“Replace Photocondctr”.
•
However, the printer repeatedly indicates the “Replace Photocondctr” with the
LED flashing every time it receives a print job after the power back on,
cancelling a job, or resetting.
•
After the “Replace Photocondctr” with the LED flashing, the remaining amount
of toner is indicated as 0%.
Remove Photocondctr
Explanation
This occurs when Photoconductor Unit is installed before all the Toner Cartridges
are installed when setting up the printer.
This error is provided to make sure that the covers (packing materials) of
HOUSING ASSY-DEVEs are removed. If the photoconductor is installed and the
HOUSING ASSY-DEVEs rotate with the covers attached, both of them could
result in malfunction. Since the Toner Cartridges cannot be installed unless the
covers removed, the printer indicates the error when the Photoconductor is
installed before attaching the four Toner Cartridges.
Remedy
Open the cover B, take out the Photoconductor Unit, and close the cover B.