Fujitsu 9045 Network Indicator, 10/100Base-T, 100Base-T Dipswitch Settings, Dipswitch Comments

10/100Base-T

Network Indicator

The NET LED displays the status of the network link. When the NET LED is on, this confirms link integrity. The NET LED flashes off for 1/3 second when a data packet is being transferred. When the NET LED is off, the network connection has been severed.

Dipswitches

On the back of the 10/100Base-T interface, you will find a small window where you can access two dipswitches labeled 1 and 2 (see Figure 2). The functions of the dipswitches are explained in Table 5.

		Table 5. 10/100Base-T Dipswitch Settings
Dipswitch
			Comments
1	2
off	off		Normal operation. With both dipswitches in the “off”
			position, the PrintNet boots up using the settings in
			flash memory rather than the default settings.
on	off		Factory default settings. With the dipswitches in this
			configuration, the PrintNet boots up and all settings
			stored in flash memory are erased except the Ethernet
			address and key value.
off	on		Default IP. With the dipswitches in this configuration,
			the PrintNet boots up with factory default settings.
			However, the stored settings in flash memory are
			intact. Setting dipswitch 2 to “on” does not clear any
			settings stored in flash memory; it boots the unit in a
			different state with the settings in flash memory
			temporarily ignored.
on	on		If the PrintNet is connected to a network with link
			integrity and then reset to MOS, a download will be
			forced. If the unit is not connected to a network, it will
			print a test page.

19