Procedure

Downloading Software

Emulation and operating system software must be loaded into flash memory on the controller board. This software is stored as a compressed file on a 3.5 inch, double-density floppy diskette. The software can be downloaded from the host computer to the printer’s flash memory using PrintNet.

Procedure

1.Make a printout of all saved configurations. (Refer to the Operator’s Manual.) (Installing new software erases all saved configurations. You will use the printouts to restore printer configuration.)

2.Set the printer power switch to O (off).

3.On the printer control panel, press and hold down the ONLINE + FF keys. Without releasing the keys, power the printer on. Continue holding the ONLINE + FF keys down.

4.When you see “WAITING FOR PROGRAM DOWNLOAD” on the LCD, release the ONLINE + FF keys.

5.On the host computer, create a temporary directory called “download” on the c: drive. From an MS-DOS®prompt, type:

md c:\download <Return>

6.Insert the emulation or upgrade diskette into diskette drive A (or B) of the host computer.

7.Make the diskette drive the active drive by typing the following at the DOS prompt:

A:<Return>

(If the diskette is in drive B, type B: <Return>)

153

Page 153
Image 153
Fujitsu 9045 user manual Downloading Software, Procedure, Md c\download Return