Chapter 2 Configuration Tools
The procedure for changing any of the parameters is the same. The procedure for changing the IP Address is given here as an example. Use the same procedure for the other required parameters. To change the IP Address parameter:
1.Make sure the printer is on and raise the printer cover.
2.Press the ONLINE key to place the printer in the OFFLINE mode.
3.Unlock the ENTER key. Refer to the Operating Manual for instructions.
4.Press the LEFT or RIGHT arrow key until the LCD displays
“ETHERNET PARAMS.”
5.Press the DOWN arrow key to access the “IP Address” parameter.
6.Press the DOWN arrow key to view the current IP Address.
7.Press the DOWN arrow key to access the portion of the IP Address to be changed.
8.Press the LEFT or RIGHT arrow key to select the portion of the IP Address to be changed.
9.Press the DOWN arrow key.
10.Press the LEFT or RIGHT arrow key to select the desired value.
11.Press the ENTER key to make the selection. An asterisk appears to the right of the value.
12.Press the UP arrow key and you will be returned to step 8.
13.When you are finished changing parameters, exit the configuration menus and lock the ENTER key. (Refer to your printer's Operating Manual for details.)
CAUTION When a change is made from the control panel, the PrintNet is re- initialized. The messages “ENET IS RESET” and “ENET IS INIT” display on the control panel. This process takes several minutes. Make sure not to shut the printer off or make further changes to the PrintNet settings during this initialization period to prevent a loss of PrintNet configuration information. When the initialization is complete, the message “ENET IS READY” is displayed.
24
