
Chapter | 6 | Novell Host Configuration |
|
|
|
|
|
|
2.You should now see a prompt displayed that has the PrintNet’s IP address followed by a colon then root.
ipaddress:root>
3.At the prompt, enter:
store pserver novell tree tree
4.Reset the unit to make the changes take effect. reset
Novell Host Configuration (10/100Base-T)
This section covers PSERVER and RPRINTER/NPRINTER setups on the PrintNet. The PrintNet can handle up to eight RPRINTER/NPPRINTER setups.
Even though the entire print setup is done through Netware Administrator or PCONSOLE, you may need to communicate directly with the print server in order to modify settings, monitor the unit, etc.
For Netware 4.x environments, you can obtain a NWAdmn3x
NOTE: NWAdmn3x is only included with Netware 4.11 and higher releases. If you are using Netware 4.10, you can either upgrade to Netware 4.11, or go to Novell’s web site and get the patches to upgrade the Nwadmin program for Netware 4.10 to Nwadmn3x for Netware 4.11. Alternatively, you can perform the setup without using MPAdmin.
NDS PSERVER Setup (Netware 4.x)
There are a number of possible ways to configure the PrintNet for use in a Novell NDS PSERVER setup. These include using the MPAdmin
104