Store Commands
Complete Command List
This section outlines the entire PrintNet command set including the command syntax, a description, and in most cases, an example for each command listed.
NOTE: If you see the word “ifnum ” in any npsh commands, you should substitute a “1” unless told otherwise. This “ 1” represents the one network interface (i.e., Ethernet) supported.
Store Commands
These commands change the settings stored in flash memory and do not affect the current or working settings in memory. A power cycle is needed before the stored settings become current.
store ifc ifnum utp [-]li [-]rx
store ifc 1 utp li
Modify the physical UTP interface properties where li enables link integrity and rx enables the increased receive threshold.
store ifc from default
Set all UTP settings back to factory defaults.
store ifc from current
Store all current UTP settings to flash memory so they are retained after a power cycle. This ensures all current settings match what is stored in flash memory.
store pserver opts
store pserver opts jobsecurity jobtimeout 5
If jobsecurity is disabled, any user can cancel queued jobs on the PrintNet including guest users. If jobtimeout is set to some value other than 0, the PrintNet will only wait this amount of seconds when getting printer feedback. This is only used if you have a logpath port and type set on a particular destination.
127
