NetWare Version 4.x PSERVER Setup
28.Wait two minutes and then check your PSERVER to see if the appropriate printer is being serviced. The PSERVER should indicate that the printer is “Waiting for job.”
At this point, the PrintNet knows to receive any jobs this PSERVER.NLM has to send to it through the defined printer.
NetWare Version 4.x PSERVER Setup
PrintNet destinations are case sensitive and will not be recognized if they are typed incorrectly. By default, they are all lower case. If you are setting up a NetWare 4 environment, the destination must be renamed to uppercase to match the PCONSOLE entry.
The PrintNet can be used in a NetWare 4 environment with either of the following options:
•Set the PrintNet up as a PSERVER, replacing a dedicated printer.
•Set the PrintNet up as an RPRINTER, interacting with an existing PSERVER (see page 86).
NOTE: Following a PSERVER setup, bindery emulation is required.
To configure the PrintNet as a PSERVER in a NetWare 4 environment:
1.Log in to the Novell as supervisor.
2.Enter PCONSOLE.
3.Press F4.
4.Select PRINT QUEUES.
5.Press INSERT to add a queue.
6.Type in new queue name and press ENTER.
7.Press ESCAPE.
8.Select PRINT SERVERS.
9.Press INSERT to add the new print server.
10.Type the name of the PrintNet. By default, it is “M_xxxxxx” where “xxxxxx” equals the last six digits of the Ethernet address
(e.g., M_000BF5).
11.Select this new print server and press ENTER.
83
