Fujitsu DL6400 manual Cnt-Org, Cntfine, Cut-Org, Cutfine, Cnt-Lft, Cut-Lft

DL6400/6600 Book Page 29 Friday, July 31, 1998 11:42 AM

		Changing Print Adjustment Options
	Table 8–5 ADJUST options
ADJUST item	Options	Description
<CNT-ORG>		Sets the top-of-form for continuous forms in 1/6-
		inch (4.2-mm) increments from the top of the
		physical page.
	1/6 IN	The default setting is recommended if the top
	:	margin is not software specified. 1/6 inch is
	6/6 IN	preferable when the top margin is software specified.
	:
	66/6 IN
<CNTFINE>		Fine-adjusts the top-of-form for continuous forms.
	0/180, ..., 29/180	Increases the top-of-form in 1/180-inch (0.14-mm)
		increments.
<CUT-ORG>		Sets the top-of-form for single sheets in 1/6-inch
		(4.2-mm) increments from the top of the physical
		page.
	1/6 IN	The default setting is recommended if the top
	:	margin is not software specified; 1/6 inch is
	6/6 IN	preferable when the top margin is software specified.
	:
	66/6 IN
<CUTFINE>		Fine-adjusts the top-of-form for cut sheets.
	0/180, ..., 29/180	Increases the top-of-form in 1/180-inch (0.14-mm)
		increments.
<CNT-LFT>		Fine-adjusts the left print start position for
		continuous forms.
	-10/90, ..., 0,	Moves the position left or right in 1/90-inch (0.28-
	..., 10/90	mm) increments.
<CUT-LFT>		Fine-adjusts the left print start position for cut
		sheets.
	-10/90, ..., 0,	Moves the position left or right in 1/90-inch (0.28-
	..., 10/90	mm) increments.

SETUP MODE

User’s Manual 8-29