Fujitsu DL6400 manual Changing Print Adjustment Options

DL6400/6600 Book Page 28 Friday, July 31, 1998 11:42 AM

Changing Print Adjustment Options

Changing Print

Adjustment

Options

4.Repeat step (3) until all required options are changed.

5.Exit HARDWRE.

Press ONLINE to exit the HARDWRE function and reprint the <<FUNCTION>> menu.

6.Either select another function or exit setup mode, saving changes.

To exit setup mode and save changes, check that the yellow arrow on the print head is positioned beneath SAVE&END. Then press FONT or MENU.

When printing using ruled paper, use ADJUST to adjust the print position so the printout fits the ruled lines. Use ADJUST to do the following:

•Set the top-of-form.

•Fine-adjust the top-of-form.

•Fine-adjust the left print start column (left margin).

•Adjust for cumulative line-spacing errors on a page.

For the first three tasks ADJUST provides separate items for cut sheets and continuous forms. The last task applies to cut sheets only.

The top edge of paper is the physical top of the page. The logical top of the page, as understood by the printer when loading paper, is called its top-of-form, where printing starts. Printing actually starts at the position obtained by adding the following:

Top-of-form; default value = 1 inch (25.4 mm)

Top margin specified by software

Printer’s <TOP-MRG> (top margin) setting; default value = 1 line

Table 8-5 lists ADJUST items and options in the order they are printed. The procedure for changing the top-of-form follows Table 8-5.

8-28 User’s Manual