Fujitsu DL6400 manual Internal test Printer is performing its, Appears for 2 seconds immediately

#E_AppendixE Page 24 Wednesday, September 2, 1998 10:05 AM

Messages

Table E–2 Printer status messages (Continued)

Message	Meaning
Internal test	The printer is performing its
	internal hardware test. This message
	appears for 2 seconds immediately
	after the printer is turned on.
Line count = xxx	This message appears briefly when a
	line feed is executed. It indicates the
	new line position for printing,
	where line 001 is the top-of-form
	position.
Loading/Unloading paper	The printer is loading paper to the
	print position or unloading paper
	to the tractor.
NOTE: Values are lost if	This message appears when you exit
power is turned off.	setup mode by selecting USE,
	which temporarily save the changes
	you made. When you turn the
	printer off, the changes are lost.
NOTE: Values have been	This message appears when you exit
permanently saved.	setup mode by selecting SAVE,
	which permanently saves the
	changes you made, making them
	the printer's new power-on default
	settings.
Now resetting	The printer is clearing its print
	buffer and resetting itself for
	printing.
Offline setup mode	This message appears briefly when
	you enter setup mode using the
	control panel. It is the opening
	message of offline setup mode.
Offset (n/180”) = xxxx	This message briefly appears when a
	micro line feed is executed. It
	indicates the offset from the current
	print line in units of 1/180 inch,
	where xxxx is –128 to +127.

E-24 User’s Manual