Fujitsu DL6400 manual Using Diagnostic Functions

DL6400/6600 Book Page 38 Friday, July 31, 1998 11:42 AM

Using Diagnostic Functions

	•	Turn off the printer.
	• While pressing LOCK, FONT, and MENU, turn the printer on.
		Continue pressing until the printer beeps.
	3. Default values for MENU1 and MENU2 set at shipment
	Table 8-3 lists the default values for MENU1 and MENU2 set at
	shipment. Reset these values using the procedure described here.
	This procedure does not reset the printer's hardware, printing
	adjustment, and configuration options.
	•	Enter setup mode.
		Place the printer offline and then press FONT and MENU
		simultaneously. Wait for the printer to stop printing and check
		that the <<FUNCTION>> menu is printed.
<<FUNCTION>>
SAVE&END	MENU1 MENU2 HARDWRE ADJUST CONFIG DEFAULT LIST SELF-TST HEX-DUMP
V-ALMNT	GAP-ADJ	(GAP-ADJ is printed only with APTC installed.)
	•	Select DEFAULT.

Using

Diagnostic

Functions

Repeatedly press LOCK to position the yellow arrow beneath DEFAULT. Press FONT or MENU to select DEFAULT. The printer reprints the <<FUNCTION>> menu. The default values in MENU1 and MENU2 are now reset.

•Either select new options for MENU1 or MENU2 or exit setup mode, saving the default values set at shipment.

To exit setup mode and save new default settings, check that the yellow arrow is positioned beneath SAVE&END. Then press FONT or MENU.

For more information, see “Changing MENU1 and MENU2 Options” on page 8-11.

This section explains how to use the SELF-TST, HEX-DUMP, and V- ALMNT diagnostic functions.

Use these functions to check printing quality and diagnose printer problems. Note that HEX-DUMP is used mainly by programmers.

8-38 User’s Manual