Fujitsu DL6400 manual 30 mm

#07_Chapter07 Page 5 Wednesday, September 2, 1998 10:01 AM

Continuous Forms

☞

4.Binding holes in the scanning area of the sensor

The shaded area shown in the figure indicates the scanning area of the sensor in which binding holes may lie. Their size is subject to the following restrictions as described and illustrated.

Any binding hole completely in the shaded area must be 7 mm (0.28 in) or less in diameter.

Caution:

Always avoid printing on the binding holes. This could damage the print head.

30 mm
(1.2 in)	10 mm (0.4 in)

First character

Binding holes

PAPER SPECIFICATIONS

5.Perforations

The perforations in continuous forms must meet the following conditions:

The ratio of cut to uncut areas for single-part continuous forms must be 3:1.

User’s Manual 7-5