
DL6400/6600 Book Page 42 Friday, July 31, 1998 11:42 AM
Using Diagnostic Functions
You can also enter hex dump mode by turning off the printer and then turning it back on while pressing ONLINE and LF/FF. Continue pressing the buttons until the printer beeps.
Checking vertical print alignment (V-ALMNT)
This example shows how printing looks when characters are vertically misaligned. Note that the left margin is not straight.
Check that continuous forms are loaded. If possible, use forms at least 356 mm (14 inches) wide to avoid printing on the platen. For letter or A4 size, set WIDTH in MENU1 to 8 inches. See “Changing MENU1 and MENU2 Options” on page
1.Enter setup mode.
Place the printer offline and then press FONT and MENU simultaneously. Wait for the printer to stop printing and check that the <<FUNCTION>> menu is printed.
<<FUNCTION>> |
|
|
SAVE&END | MENU1 MENU2 | HARDWRE ADJUST CONFIG DEFAULT LIST |
|
|
|
2.Select
Repeatedly press LOCK to position the yellow arrow on the print head beneath
3.Adjust vertical alignment as follows:
Check the parallel bars. When they are aligned (not jagged), go to step (4). If they are offset to the left, repeatedly press FONT until
User’s Manual |