Fujitsu DL6400 manual Select SAVE&END, Resetting Default Values

DL6400/6600 Book Page 37 Friday, July 31, 1998 11:42 AM

Resetting Default Values

Important:

The only way to exit setup mode without saving changes is to turn off the printer. Turning the printer back on activates the previous default settings.

To exit setup mode and save changes using SELF-TST, see “Test Printing (SELF-TST)” on page 8-38. To exit setup mode and save changes using SAVE&END, do the following:

1.Print the <<FUNCTION>> menu.

The <<FUNCTION>> menu should be the last printed line on the page. If it is not printed, press ONLINE to print it. If using SELF- TST or HEX-DUMP, press LOCK instead of ONLINE.

<<FUNCTION>>
SAVE&END	MENU1 MENU2	HARDWRE ADJUST CONFIG DEFAULT LIST SELF-TST HEX-DUMP
V-ALMNT	GAP-ADJ	(GAP-ADJ is printed only with APTC installed.)

2. Select SAVE&END.

SETUP MODE

Resetting Default Values

Check that the yellow arrow on the print head is positioned beneath SAVE&END. Press FONT or MENU to select SAVE&END. The printer exits setup mode and goes back online (the ONLINE indicator glows green). Any changes made in setup mode are saved.

When resetting the printers default values, default values set at shipment or default values for MENU1 and MENU2 set at shipment make sure to reset as described in the following sections.

1. Default values

Default values activated when power is turned on are saved in the printer's permanent memory. The easiest way to reset them is to turn the printer off and then on. This procedure eliminates changes not to be saved.

2.Default values set at shipment

For a list of the default values set at shipment, see “Printing a List of Options” on page 8-8. To reset the default values for all functions, do the following:

User’s Manual 8-37