
DL6400/6600 Book Page 8 Friday, July 31, 1998 11:42 AM
Turning Printer Power On and Off
Turning Printer
Power On and
Off
☞
☞
Test Printing
Turn power on or off as follows:
1.On
Press the power switch at the left on the front of the printer to turn the printer on ( ). Depending on the switch settings, lamps will light.
Notice:
Do not touch any other control panel button when turning power on or off. Otherwise, you may activate a maintenance mode for other than test printing.
2.Off
Press the power switch to turn the printer off (❍). Lamps go out.
Notice:
Wait at least 3 seconds before turning on power again after turning it off. Otherwise, a printer fault may occur.
The printer's
For the operation of the printer with the LCD control panel, see Appendix E.
Make sure paper is loaded. Check that the paper thickness lever is set to the appropriate position (see “Installing the Ribbon Cassette” on page
1.Turn off the printer.
2.Holding down the LF/FF button, turn the printer back on.
Hold LF/FF down until the printer beeps. Test printing will start then.
3.To stop printing, press the FONT or MENU button. To remove the test page, turn the platen knob clockwise.
User’s Manual |