Fujitsu DL6400 Tear-En Sec, Cutload Auto, Button, Loadtim, Decode, Direct, ESC Q # IBM XL24E

DL6400/6600 Book Page 33 Friday, July 31, 1998 11:42 AM

Changing Configuration Options

Table 8–6 CONFIG options (Continued)

CONFIG item	Options	Description
<TEAR-EN>	0 SEC	Specifies the offset time when tearoff is enabled.
		The offset time is measured from when data transfer stops
	1 SEC	to when the printer performs automatic tearoff feed. If the
	2 SEC	printer receives data again within the offset time, the
	4 SEC	printer does not perform automatic tearoff feed. In some
	6 SEC	application programs, data transfer may stop temporarily
		because of internal processing. This setting can prevent
		undesired tearoff feed by causing the printer to wait for up
		to 6 seconds each time data transfer stops.
<CUTLOAD>	AUTO	Specifies how cut sheets are loaded using the front table.
		Cut-sheet paper is automatically loaded within a certain
	BUTTON	time after paper is loaded.
		Cut-sheet paper is loaded by pressing the LOAD button
		(or LOAD/UNLOAD button).
The <LOADTIM> item is printed when AUTO is specified for the <CUTLOAD> item.
<LOADTIM>		Autoload start time.
	0.5, 1.0,	Autoloading starts when this time passes after cut-sheet
	1.5, 2.0,	loading.
	2.5, 3.0 SEC
<DECODE>		Specifies the timing of command decoding.
	DIRECT	The printer decodes certain commands right after receiving
		data.
		Example:
		ESC SUB I, ESC CR P (DPL24C+)
		ESC Q # (IBM XL24E)
	QUEUED	The printer decodes commands after storing all data
		(including commands) in the input buffer. This speeds
		data reception because the printer needs no decode time
		during data reception.
<ON-LOAD>		Printer status after loading paper in offline mode.
	OFF LINE	Remains offline after paper loading.
	ONLINE	Goes into online after paper loading.

SETUP MODE

User’s Manual 8-33