Removing and replacing the control panel bezel

1

2

3

1Unplug the power cord from the printer.

Note

If you have a 220V product, turn off the power switch.

2Remove the existing control panel bezel by lifting up on both sides of the bezel edges until all the snaps are disengaged. Set the old bezel aside.

CAUTION

Be careful not to touch any components or buttons inside the exposed control panel area.

3Align the new bezel at the lower notch. The bezel notch should align to the inside of the printer.

4Press down until all the snaps are engaged, and then press outward until the bezel is secured.

5Plug the printer in to turn it back on. If you have a 220V product, turn on the power switch.

4

EN

Removing and replacing the control panel bezel 135

Page 137
Image 137
Hitachi 3300MFP manual Removing and replacing the control panel bezel