Message | Description |
|
|
Unicast Packets | Number of frames specifically addressed to this print server. This does not |
Received | include broadcasts or multicasts. |
|
|
Bad Packets Received | Total number of frames (packets) received with errors by the print server. |
|
|
Framing Errors | Maximum of CRC (Cyclic Redundancy Check) errors and framing errors. |
Received | CRC errors are frames received with CRC errors. Framing errors are |
| frames received with alignment errors. A large number of framing errors |
| could indicate a cabling problem with your network. |
|
|
Total Packets | Total number of frames (packets) transmitted without error. |
Transmitted |
|
|
|
Unsendable Packets | Total number of frames (packets) not successfully transmitted because of |
| errors. |
|
|
Transmit Collisions | Number of frames not transmitted because of repeated collisions. |
|
|
Transmit Late | Total number of frames not transmitted because a late collision occurred. A |
Collisions | large number may indicate a cabling problem on the network. |
|
|
TCP/IP protocol information
Provides the current status and parameter values for the TCP/IP network protocols.
Message | Description | |
|
| |
Status | Current TCP status: | |
| ● | Ready the print server is awaiting data over TCP/IP. |
| ● | Disabled TCP/IP was manually disabled. |
| ● | Initializing the print server is searching for the BOOTP server, or |
|
| trying to get the configuration file through TFTP. An additional status |
|
| message may also be displayed. |
| An error code and message are displayed if the print server is not ready. | |
|
| |
Host Name | The host name configured on the print server. It may be truncated. | |
| ● | Not Specified no host name was specified in a BOOTP response |
|
| or TFTP configuration file. |
| ● | NPIxxxxxx the default name is NPIxxxxxx, where xxxxxx represents |
|
| the last six digits of the LAN hardware (MAC) address. |
|
| |
IP Address | The Internet Protocol (IP) address assigned to the print server. This is a | |
| required entry for its operation on a TCP/IP network. During initialization, a | |
| temporary value 0.0.0.0 is displayed. After two minutes, a default IP | |
| address 192.0.0.192 is assigned, which may not be a valid IP address for | |
| your network. | |
| ● | Not Specified an IP address is not assigned or the value is zero. |
200 16 Troubleshooting network problems | EN |
