Hitachi SJ200 Series manual 126

3–54

“C” Group: IntelligentTerminal Functions

		“C” Function			Run		Defaults
Func.	Name /			Description	Mode	–FEF	–FU	Units
					Edit
Code	SRW Display					(EU)	(USA)
C143	Logic function select		Applies a logic function to		✘	00	00	—
			calculate [LOG] output state,
	LogicOPE	AND
			three options:
			00	... [LOG] = A AND B
			01	... [LOG] = A OR B
			02	... [LOG] = A XOR B

Configuring Drive Parameters

Output Signal ON/OFF Delay Function - Intelligent outputs including terminals [11], [12], and the output relay, have configurable signal transition delays. Each output can delay either the OFF-to-ON or ON-to-OFF transitions, or both. Signal transition delays are variable from 0.1 to 100.0 seconds. This feature is useful in applications that must tailor inverter output signals to meet timing requirements of certain external devices.

		“C” Function		Run		Defaults
Func.	Name /		Description	Mode	–FEF	–FU	Units
				Edit
Code	SRW Display				(EU)	(USA)
C144	Terminal [11] ON delay		Range is 0.0 to 100.0 sec.	✘	0.0	0.0	sec.
	DLAY 11	0000.0s
C145	Terminal [11] OFF		Range is 0.0 to 100.0 sec.	✘	0.0	0.0	sec.
	delay
	HOLD 11	0000.0s
C146	Terminal [12] ON delay		Range is 0.0 to 100.0 sec.	✘	0.0	0.0	sec.
	DLAY 12	0000.0s
C147	Terminal [12] OFF		Range is 0.0 to 100.0 sec.	✘	0.0	0.0	sec.
	delay
	HOLD 12	0000.0s
C148	Output relay ON delay		Range is 0.0 to 100.0 sec.	✘	0.0	0.0	sec.
	DLAY RY	0000.0s
C149	Output relay OFF delay		Range is 0.0 to 100.0 sec.	✘	0.0	0.0	sec.
	HOLD RY	0000.0s

NOTE: If you are using the output terminal OFF delay feature (any of C145, C147, C149 > 0.0 sec.), the [RS] (Reset) terminal affects the ON-to-OFF transition slightly. Normally (without using OFF delays), the [RS] input causes the motor output and the logic outputs to turn OFF together, immediately. However, when any output uses an OFF delay, then after the [RS] input turns ON, that output will remain ON for an additional 1 sec. period (approximate) before turning OFF.