Orientation to Inverter Features
Inverter Mounting | and Installation |
|
|
Orientation to Inverter Features
Unpacking and Inspection
Please take a few moments to unpack your new SJ200 inverter and perform these steps:
1.Look for any damage that may have occurred during shipping.
2.Verify the contents of the box include:
a.One SJ200 inverter
b.One Instruction Manual
c.One SJ200 Quick Reference Guide
3.Inspect the specifications label on the side of the inverter. Make sure it matches the product part number you ordered.
Main Physical Features
The SJ200 Series inverters vary in size according to the current output rating and motor size for each model number. All feature the same basic keypad and connector interface for consistent ease of use. The inverter construction has a heat sink at the back of the housing. The larger models include a fan(s) to enhance heat sink performance. The mounting holes are pre- drilled in the heat sink for your convenience. Smaller models have two mounting holes, while larger ones have four. Be sure to use all the mounting holes provided.
Two chassis GND screws are located on the metal tab on the heat sink at the bottom of the inverter. Never touch the heat sink during or just after operation; it can be very hot.
The electronics housing and front panel are built onto the front of the heat sink.
Inverter Keypad - The inverter uses a digital operator interface, or keypad. The
2keys allow an operator to navigate to the inverter’s functions and parameter values. The Store key is used when changing a setting.