SJ200 Inverter
If the Potentiometer Enable LED is OFF, follow the steps below.
Action | Display | Func./Parameter |
|
|
|
(Starting point) | A – – – | “A” Group selected | ||
| ||||
|
|
|
| |
Press the FUNC. key. | A 0 0 1 | Speed command source setting | ||
|
| |||
|
|
|
|
|
Press the FUNC. key again. | 0 1 | 00 | = Keypad potentiometer | |
01 | = Control terminals | |||
|
|
| 02 | = Function F001 setting |
|
|
| 03 | = ModBus network |
|
|
| 10 | = Calculate function output |
|
|
|
|
|
Press the 2 | key. | 0 0 | 00 | = potentiometer (selected) |
|
| |||
|
|
|
| |
Press the STR | key. | A 0 0 1 | Stores parameter, returns to “A” | |
Group list | ||||
Select the Keypad for the RUN Command - The RUN command causes the inverter to accelerate the motor to the selected speed. The Run command can arrive from various sources, including the control terminals, the Run key on the keypad, or the network. In the figure to the right, notice the Run Key Enable LED, just above the Run key. If the LED is ON, the Run key is already selected as the source, and you may skip this step. Note that the default setting depends on the country.
Run Key Enable LED
HITACHI POWER 
5 0.0 |
| A | ||||
|
|
|
|
| ALARM | |
| HITACHI |
| Hz | |||
|
|
|
|
| ||
|
|
|
| RUN | ||
| RUN | STOP | PRG | |||
| RESET |
|
|
| ||
|
|
|
|
| ||
| FUNC 1 2 | STR | ||||
|
|
|
|
|
|
|
If the Potentiometer Enable LED is OFF, follow the steps below (the table resumes action from the end of the previous table).
Action | Display | Func./Parameter |
|
|
|
(Starting point) | A 0 0 1 | Speed command source setting | |||
| |||||
|
|
|
|
| |
Press the | 1 | key once. | A 0 0 2 | Run command source setting | |
|
| ||||
|
|
|
|
| |
|
|
|
|
|
|
Press the FUNC. key. | 0 1 | 01 | = control terminals | ||
02 | = Run key on keypad | ||||
|
|
|
| 03 | = ModBus network input |
|
|
|
|
|
|
Press the | 1 | key. | 0 2 | 02 | = keypad (selected) |
|
| ||||
|
|
|
|
| |
|
|
|
|
| |
Press the STR | key. | A 0 0 2 | Stores parameter, returns to “A” | ||
Group list | |||||
NOTE: After completing the steps above, the Run Key Enable LED will be ON. This does not mean the motor is trying to run; it means that the RUN key is now enabled. DO NOT press the RUN key at this