Hitachi SJ200 Series manual 251

B–37

SJ200 Inverter

	“C” Group Intelligent Terminal Functions
Func.	Name	R/W	Description	Network Data
Code				Reg.	Range	Res.
C041	Overload level setting	R/W	Sets the overload signal level	00BBh	0 to	0.01 %
			between 0% and 200% (from 0		20000
			to two times the rated current
			of the inverter)
C042	Frequency arrival	R/W	Sets the frequency arrival	00BCh	0 to 4000	0.1 Hz
	setting for acceleration		setting threshold for the output		*1
			frequency during acceleration,
			range is 0.0 to 400.0 Hz				BAppendix
C044	PID deviation level	R/W	Sets the allowable PID loop	00BEh	0 to 1000	0.1 %
C043	Arrival frequency	R/W	Sets the frequency arrival	00BDh	0 to 4000	0.1 Hz
	setting for deceleration		setting threshold for the output
			frequency during deceleration,
			range is 0.0 to 400.0 Hz
	setting		error magnitude (absolute
			value), SP - PV, range is 0.0 to
			100%, resolution is 0.1%
C052	PID FBV function high	R/W	When the PV exceeds this	00EAh	0 to 1000	0.1 %
	limit		value, the PID loop turns OFF
			the PID Second Stage Output,
			range is 0.0 to 100.0%
C053	PID FBV function low	R/W	When the PV goes below this	00EBh	0 to 1000	0.1 %
	limit		value, the PID loop turns ON
			the PID Second Stage Output,
			range is 0.0 to 100.0%
C071	Communication speed	—		00C0h	—	—
	selection
C072	Node allocation	—		00C1h	—	—
C074	Communication parity	—	NOTE: These network settings	00C3h	—	—
	selection
			are not accessible to ModBus.
C075	Communication stop bit	—		00C4h	—	—
			Use the inverter keypad or
	selection
			digital operator to edit. Refer to
C076	Communication error	—	“Network Communication	00ECh	—	—
	select		Settings” on page 3–50.
C077	Communication error	—		00EDh	—	—
	time-out
C078	Communication wait	—		00C5h	—	—
	time
C081	O input span calibration	R/W	Scale factor between the	00C7h	0 to 2000	0.1 %
			external frequency command
			on terminals L – O (voltage
			input) and the frequency
			output, range is 0.0 to 200.0%