HP 5000n manual Tray 1 Inner Cover, 24Removing and Replacing Parts

CAUTION

Figure 6-16

Tray 1 Inner Cover

1Remove the Top Cover (page 6-12), Left and Right Side Covers (page 6-23), and Front Cover and Tray 1 (page 6-18).

Be sure to locate the Paper Sensor Flag on the left side of the Cover, before proceeding to step 3. It rests in an indention in the left side of the chassis and is easily broken. See Figure 6-16.

2The Tray 1 Inner Cover is a plastic tray located at the top front of the printer. Remove the two self-tapping screws, (A) in Figure 6-17, holding the Cover to the front of the chassis.

Tray 1 Inner Cover Flag (view from inside printer, left side)

3Facing the front of the printer, slip the Cover off of the locating pins.

Hint	To install a self-tapping screw, first turn it to the left until it clicks,
	indicating the threads are seated. Then, turn it to the right to tighten.
	Do not over-tighten. If a self-tapping screw-hole becomes stripped,
	repair of the screw-hole or replacement of the affected assembly is
	required.

6-24Removing and Replacing Parts EN