HP 5000n manual Reassembly Steps, 44Reassembly of Tray 2 Shaft

Reassembly Steps:

1Tip the printer back, so that the front faces up.

2Insert the shaft into the fitting on the right side. Then, angle the shaft into the other side.

3Place the bushing on the right end of the shaft, and push until the tab locks in the indentation in the shaft.

4Facing the left side of the printer, orient the shaft so that the open end points away from the solenoid. See Figure 6-44.

5Depress the solenoid arm, and slide the gear into place. Press it into the plastic collar until it locks in place.

6Reinstall the spring on the arm of the gear.

Figure 6-44Reassembly of Tray 2 Shaft

Item

A

Explanation

Direction to Orient Shaft

EN Removing Assemblies 6-55