HP 5000n manual Press GO to Continue Parallel I/O Buffer Overflow

Table 7-6. Numerical Printer Messages (continued)

Control Panel	Event	Explanation	Recommended
Message	Log		Action
	Message

22 EIO x

BUFFER OVERFLOW

alternates with

Too much data was sent to the EIO card in the specified slot (x).

Press [Go] to clear the message. (Data will be lost.)

PRESS GO TO

CONTINUE

22 PARALLEL I/O

BUFFER OVERFLOW

alternates with

PRESS GO TO

CONTINUE

22 SERIAL I/O

BUFFER OVERFLOW

alternates with

PRESS GO TO

CONTINUE

Too much data was sent to the parallel port.

This error can occur if the driver you are using is not IEEE-1284 compliant. For best results, use an HP driver that came with the printer.

Too much data was sent to the serial port.

Check for a loose cable connection and be sure to use a high-quality cable. (Some non-HP parallel cables might be missing pin connections, or might otherwise not conform to the IEEE-1284 specification.)

Press [Go] to clear the error message. (Data will be lost.)

1.Make sure the correct serial pacing option is selected from the I/O Menu in the printer’s Control Panel.

2.Print a Menu Map and verify that the serial pacing item (from the I/O Menu in the printer’s Control Panel) matches the setting on the computer.

3.Press [Go] to clear the error message. (Data will be lost.)

EN Troubleshooting the Printing System 7-29