HP 5000n manual To enter Service Mode, 30Printer Operation

Service Mode

Service Mode should be used only by authorized service personnel. While in Service Mode, you can:

●Verify and set the page count and serial number. These are displayed on the Configuration Page.

●Set the Cold Reset Default. (This sets the factory default paper size to either Letter or A4).

●Turn the Diagnostic Functions on or off (for developers only).

●Clear the event log.

●Set the interval at which the PERFORM PRINTER MAINTENANCE message appears on the control panel.

To enter Service Mode:

1Hold down [Select] and [Cancel Job] while turning on the printer. (If the control panel reads INITIALIZING, the keys were released too soon.)

2Press the right side of the [Menu] key, then press [Select]. The message SERVICE MODE is displayed. To exit the Service Mode press [Go].

3-30Printer Operation EN