All Rights Reserved. Reproduction, adaptation, or translation without permission is prohibited, except as allowed under the copyright laws.
HP part number
First
Second
Third
Fourth
Fifth
Fifth
Sixth
Printed in USA
Warranty
The information contained in this document is subject to change without notice.
Safety Information
The HP 5890 Series II and HP 5890 Series II Plus are IEC (International Electrotechnical Commission) Safety Class 1 instruments. This unit has been designed and tested in accordance with recognized safety standards. Whenever the safety protection of the HP 5890 Series II has been compromised, disconnect the unit from all power sources and secure the unit against unintended operation.
Safety Symbols
This manual contains safety information that should be followed by the user to ensure safe operation.
WARNING
A warning calls attention to a condition or possible situation that could cause injury to the user.
CAUTION
A caution calls attention to a condition or possible situation that could damage or destroy the product or the user’s work.
Important User Information for In Vitro Diagnostic Applications
This is a multipurpose product that may be used for qualitative or quantitative analyses in many applications. If used in conjunction with proven procedures (methodology) by qualified operator, one of these applications may be In Vitro Diagnostic Procedures.
Generalized instrument performance characteristics and instructions are included in this manual. Specific In Vitro Diagnostic procedures and methodology remain the choice and the responsibility of the user, and are not included.
Sound Emission Certification for Federal Republic of Germany
If Test and Measurement Equipment is operated with unscreened cables and/or used for measurements in open
The following information is provided to comply with the requirements of the German Sound Emission Directive dated January 18, 1991
Sound pressure Lp < 70db(A)
During normal operation At the operator position
According to ISO 7779 (Type Test)
When operating the HP 5890 Series II with cryo valve option, the sound pressure ‘ 78 db(A) during cryo valve operation for short burst pulses.
Schallemission
Werden Meß- und Testgeräte mit ungeschirmten Kabeln und/oder in offenen Meßaufbauten verwendet, so ist vom Betreiber sicherzustellen, daß die
Diese Information steht im Zusammenhang mit den Anforderungen der Maschinenlärminformation sverordnung vom 18 Januar 1991.
Schalldruckpegel LP < 70 dB(A)
Am Arbeitsplatz
Normaler Betrieb
Nach DIN 45635 T. 19 (Typprüfung)
Bei Betrieb des HP 5890 Serie II mit Cryo Ventil Option treten beim Oeffnen des Ventils impulsfoermig Schalldrucke Lp bis ca. 78 dB(A) auf.
Little Falls Site