HP and 8150 MFP manual Chapter Problem Solving 232 Printer Messages, Initializing, Spinning UP

Chapter 5	Problem Solving	232
Printer Messages (continued)
Message	Explanation or Recommended Action

EIO n

INITIALIZING

alternates with

DO NOT POWER OFF

Wait for the message to disappear (approximately 5 minutes). If the printer EIO card is operating correctly and communicating with the network, this message disappears after approximately one minute and no action is required.

If the EIO card is unable to communicate with the network, this message remains for five minutes and then disappears. In this case the printer is not communicating with the network (even though the message is no longer present). The problem may be a bad EIO card, a bad cable or connection on the network, or a network problem. Contact your network administrator.

EIO n DISK	The disk accessory card takes a long time to initialize. The first
SPINNING UP	parameter is the accessory slot number for this accessory card.
ENV FEEDER LOAD	Load the requested envelope type and size into the envelope
[TYPE] [SIZE]	feeder.
	Make sure the envelope size and type are set correctly from the
	Paper Handling Menu in the printer’s control panel (page 427).
	Press GO if the desired envelope is already loaded in the feeder.
	Press - VALUE + to scroll through the available types and sizes.
	Press SELECT to accept the alternate type or size.

Understanding Printer Messages