HP VCX Software manual Save/Load CLI Command File

Chapter 7. Administration

Save to diskette

Insert a formatted diskette into the Telecommuting Module’s floppy drive and press Save to diskette to save the preliminary configuration. Do not remove the diskette until the light on the floppy drive goes out.

Check that you get a confirmation of the saving. If not, the diskette may be faulty.

Load from diskette

Insert the diskette with the saved configuration into the Telecommuting Module’s floppy drive and press Load from diskette. Do not remove the diskette until the light on the floppy drive goes out. The contents of the diskette are now loaded in the preliminary configuration.

Save to local file

Press Save to local file to save the preliminary configuration to the file you have selected. A new window is opened where you enter the name of the file.

Load from local file

Press Load from local file to load a new preliminary configuration from the file you have selected.

Browse

Browse is used to scan your local disk. The web browser opens a new window where you can search among files and directories. Go to the right directory and select the file you want to upload.

Save/Load CLI Command File

All configurations can be saved to and loaded from a CLI file (see chapter 18, Command Line Reference, for more information about the CLI). You can also edit the CLI file before it is uploaded again.

Uploading a CLI file might affect the permanent configuration, as the CLI file can contain commands that applies the configuration.

Save config to CLI file

Press Save config to CLI file to save the preliminary configuration to the file you have selected. A new window is opened where you enter the name of the file.

Load CLI file

Press Load CLI file to upload a CLI file to the Telecommuting Module.

105