Chapter 7. Administration
Change Date and Time With NTP
Instead of setting the time manually, you can let the Telecommuting Module get the correct time from an NTP server. The time for synchronizing will be notably shorter if the Telecom- muting Module time is approximately correct when NTP is activated.
N.B. Before you change time here, make sure that the Telecommuting Module uses the correct time zone above.
Synchronize time with NTP
Here, select if NTP synchronizing should be enabled or not.
Enter servers to sync with in the table below.
Dynamic
If an interface will receive its IP address from a DHCP server, the Telecommuting Module can also get information about its NTP server from that server. In this case, select the corresponding IP address here and leave the other fields empty.
NTP Servers To Use If NTP Is Enabled
DNS Name Or IP Address
The name/IP address of the NTP server to which the Telecommuting Module should con- nect. If a name is entered, you must enter the IP address for a name server on the Basic Configuration page.
IP address
Shows the IP address of the DNS Name Or IP Address you entered in the previous field.
Delete Row
If you select this box, the row is deleted when you click on Create new rows, Save, or Look up all IP addresses again.
Create
Enter the number of new rows you want to add to the table, and then click on Create.
115