HP VCX Software manual Password, Other

Chapter 14. Basic Administration

Enter the network address and netmask for the configuration computer network. If they are on the same network as the Telecommuting Module, these are all configuration settings needed. If the configuration computers are on a different network, the Telecommuting Mod- ule will ask for routing to that network.

Static routing:

The network allowed to configure from is not on a network local to this unit. You must configure a static route to it. Give the

IP address of the router on the network this unit is on.

The IP address of the router [0.0.0.0]: 10.47.3.1

Network address [10.47.0.0]: 10.10.0.0

Netmask [255.255.255.0]:

Enter the IP address of the router and the network to which the configuration computers are connected. This could be a bigger network than the one entered to distinguish the configura- tion computers.

Password

Set a password for the Telecommuting Module here.

Password []:

Note that the password will be printed on the screen when entered. It will also be shown when all settings are made.

Other

You can also select if all other configuration should be removed or not.

Other configuration

Do you want to reset the rest of the configuration? (y/n) [n]

If you answer n, nothing is removed. If you answer y, you have three alternatives to select from:

1.Clear as little as possible. This is the alternative that is used if you answer n to the question above. Both the preliminary and the permanent configurations will be updated with the configuration specified above.

2.Revert to the factory configuration and then apply the configuration specified above. This will affect the permanent but not the preliminary configuration.

3.Revert to the factory configuration and empty all logs and then apply the configuration specified above. Both the preliminary and the permanent configurations will be affected.

Update mode (1-3) [1]:

When all settings are entered, they are shown on the screen to be confirmed.

233