HP VCX Software manual Interface Network Interface 1, Physical device, Interface name

Chapter 8. Network Configuration

Create

Enter the number of new rows you want to add to the table, and then click on Create.

Save

Saves the Default Gateway configuration to the preliminary configuration.

Cancel

Clears and resets all fields in new rows and reset changes in old rows.

Interface (Network Interface 1 and 2)

There is a page for each network interface (Network Interface 1 and 2) on the Telecommuting Module. Select a page to make configuration for that interface. There is also a page where configuration for all interfaces can be viewed and changed.

Here, you set the interface name, whether the interface is on or off, the IP address, alias, and static routing.

For each interface, go to Directly Connected Networks and state the IP address of the Telecommuting Module and the size of the network connected to this interface.

General

Physical device

Physical device tells the physical device name of the network interface.

Status

Specify if this network interface is On or Off. If the interface is off, all configuration on this page is ignored, and the Telecommuting Module will behave as if this interface wasn’t present.

Interface name

The network Interface name is only used internally in the Telecommuting Module, e. g. when configuring Networks and Computers.

124