HP VCX Software manual

Chapter 2. Installing 3Com VCX IP Telecommuting Module

Password []:

Finally, you are asked if you want to reset other configuration.

Other configuration

Do you want to reset the rest of the configuration? (y/n) [n]

If you answer n, nothing is removed. If you answer y, you have three alternatives to select from:

1.Clear as little as possible. This is the alternative that is used if you answer n to the question above. Both the preliminary and the permanent configurations will be updated with the configuration specified above.

2.Revert to the factory configuration and then apply the configuration specified above. This will affect the permanent but not the preliminary configuration.

3.Revert to the factory configuration and empty all logs and then apply the configuration specified above. Both the preliminary and the permanent configurations will be affected.

Select the update mode, which is what you want to remove.

Update mode (1-3) [1]:

All configuration is now complete. The installation program shows the configuration and asks if it is correct.

yes saves the configuration.

no runs the installation program over again.

abort ends the installation program without saving.

You have now entered the following configuration

Network configuration inside:

Physical device name: eth0

IP address: 192.168.150.2

Netmask: 255.255.255.0

Deactivate other interfaces: no

Computer allowed to configure from:

IP address: 192.168.128.3

Password: eeyore

The rest of the configuration is kept.

Is this configuration correct (yes/no/abort)? yes

11